Tuesday, June 13, 2017

Tool Box With Tools, From Paper & Stamps

I wanted to create this last week, but things just didn't work out. Hopefully it will help someone with a Fathers day card. This is a cute tool box equipped with tools, just using stamps and dies and a little coloring. The video is uploading and below are the measurements.

Video Tutorial:


Cardstock 11 x 8 1/2 inches
Score on long side at 2 1/2", 4", 7", 8 1/2"
Turn one turn score at 1 1/2", 7"

On the 1 1/2" score lines cut away the first rectangle on all four sides. Then just cut up on the square box that is left, this creates your tab. 

Find the center of the long center rectangle on the sides where you just cut the block away and mark lightly. Use your score tool to create a triangle box from the score line up to the mark you made. 

Glue the small tabs to the outside of the box. Then fold up the long flaps to close the box. 

If all this is confusing follow the video. 

I stamped out tools from and Altenew stamp and die set found here

Mat is 2 1/4"x 5 1/4", this is used on the long closure flaps. Decorate as desired

little closure piece is 1 x 2 inches scored in the middle and glued together. Glue one piece down and then put Velcro on the other to make the closure. 

Demo set 35% off retail, used once. Click HERE 

No comments:

Post a Comment