Little Red Wagon Treat Holder

Today we created a little red wagon treat holder we will be using at Christmas for table favors. The video tutorial is linked below as well as all the measurements and products used. Hope you enjoy and if you make one please make sure to join our groups and share your creations.

YouTube Tutorial: https://youtu.be/rpqFc2bUZXc

Products Used:

TH Glass mat: http://bit.ly/2vXmrvP

Tim Holtz Scissors: http://bit.ly/2J3lh77

Score Board: http://bit.ly/2NTdtXI

Foam Tape: https://amzn.to/2IOrGTH

Pick Up Tool: http://bit.ly/2zMUWKx

Art Glitter Glue: http://bit.ly/2FGCXmz

TH Ruler: http://bit.ly/2DK7dxO

Basic Grey Magnets: http://bit.ly/2K3Hr9M

Measurements:

Start with a piece of cardstock 6x4 inches, score at 1/2" on all 4 sides. Cut up on the small edge score lines and glue the tiny flaps together as we have on other boxes or the crate. 

For the corner post cut a piece of cardstock 3/4x2" and score at 3/8"/center.
Fold these in half and glue in place at each corner.

Rails are cut at 1/2x5 you will need 4 of these and 1/2x3 you will need 4 of these. Glue the rails in place on each side matching the corners as shown in the video.

The Tongue on the wagon is cut at 1/2x5 1/2 inches, score in the center at 1/4" and glue the pieces together.
The pull on the wagon is cut at 1/2"x3/4" and is scored in half and glued together. I cut a small corner off on each side to make it look more like a pull for the wagon. 

Wheels are cut at 1 1/4" and I cut 4 of these for each wheel and glued them together.
The center piece is cut at 3/8" and you will need 4

Put a sentiment on the side.

Fill with candy or gifts and you have a sweet gift.